Capturing the run environment in Calibre Interactive

Document created by Joel on Sep 14, 2012
Version 1Show Document
  • View in full screen mode

There are many times where you want to know what environment  variables are set to in Calibre Interactive.  This is especially true  when preparing a testcase to send to someone else.  The transcript is  the perfect place to capture this information.

 

To output the run environment Calibre is running in and capture the variables set inside Calibre Interactive, use a pre-trigger.

 

Use Setup -> Preferences -> Triggers -> Calibre  Pre-Execution Trigger.  Enter the Shell command "env".  This will add a  list of environment variables and thier settings to the top of the  transcript in Calibre Interactive.

Attachments

    Outcomes