AnsweredAssumed Answered

Setting "path closure" tolerance when building complex area fill shapes?

Question asked by gene.carman on Apr 29, 2009
Latest reply on May 15, 2009 by gene.carman

I seem to remember there was a command for defining how large the tolerace gap of endpoints of lines and arcs, in the shape edit mode, could be while allowing them to close to make a "path."

 

This is old Board Station (EN2002 or En2004) using the shape edit mode to make complex shapes.  When using fillet and trim, there are gaps created that will not allow a "path" to be created if the gaps exceed a certain size.

 

What is the command to modify that gap tolerance?

Outcomes