justin.mininni

Adding pages to harness designs?

Discussion created by justin.mininni on Sep 18, 2009
Latest reply on Sep 18, 2009 by Joel_Pointon

I am new to using VeSys 2.0 and came across a question while going through the evaluation tool.  If I have a harness drawing that will not fit onto one page, is there a way to add another page to the same section?  When I go to  File > New > New Harness Design, it adds a new folder and therefore the page is then 1 of 1 instead of being 1 of 2 in the previous folder. Hopefully this is not confusing and I explained it so you can understand.

 

Thanks

Outcomes