0 Replies Latest reply on Nov 20, 2012 9:37 PM by kabaleeswaran.K.R

    placement grid for PADS2005 ??

    kabaleeswaran.K.R

      hi everyone,

       

      in my design has BGA and VME connector,sd card power supply part, dc-dc converter is available usually in allegro for major components like BGA and VME connector placement grid is 25 mil and remaining components i will set as 5 mil or 1o mils (for resistor and decap's) if i set same grid in PADS 2005 i could not route properly

       

      1.i could not get proper teardrop (if the net has stright only i get teardrop)

      2.same net violation is occur ( even i set the value below 5mil for same net violation )

       

      so i need placement grid for major and minor components please reply any one............!