AnsweredAssumed Answered

Copy file error "design1 could not be found"

Question asked by ronald.oneal on Dec 7, 2012
Latest reply on Jan 10, 2013 by robert_davies

I am running into an error message opening up the DxDesigner schematic in a copied completed design.

The Project Navigator shows "the block: schematic1 associated with the design: design1 could not be found"

 

I believe there is a file in one of the logs that must be deleted for this error to be corrected but for the life of me, can't remember where it is.

 

I know I have seen this error on the discussion board in the past but I can't find the answer now.

 

Thanks in advance!

Ron

Outcomes