You can select the traces and set it to protection
Thank you for your reply. Your suggestion worked fine. I have one more question about PCB. Can you please tell me how to use periphery of the board for a connection on PCB.
center-tapped coil.png 246.6 KB
Select a pad at one end of the route, using the right mouse button menu, select "Route Loop" . This allows you to add multiple routes for the same pin pair.
I'm not sure what you mean when you ask about using the periphery of the board for routing?
Setting protection is a good idea. You can also route parallel traces by using the RouteLoop method.
Select Traces/Pins/Unroutes. Select a starting Pad. Right Mouse Click. Select Route Loop (or Hotkey Ctrl_J) and select the endpoint pad.
(Pads typically as a couple of ways of accomplishing the same thing).