AnsweredAssumed Answered

Connect two pads in a cell to a symbol with only one pin

Question asked by Ompz on Jan 16, 2013
Latest reply on Jan 17, 2013 by Ompz

Hello, I have a faston tab component. The simbol created by the librarian have two slots, one per each pin and the cell has two pads. the problem is I want to connect both pins of the cell with only one symbol slot because if I use insert both slots in the schematic is more difficult to understand (this PCB has 20 faston tabs. If I duplicate the number of slots, I will have 40 faston tabs simbols in the schematic ).


In DxDesigner for PADS we used the property SIGNAL and it works but  it does not work  in Expedition.


Thanks, Oscar

cell.JPG          symbols.JPG