i migrate from allegro to pads in my design i need to create T point for length matching in PADS (check figure )how to create t point in DDR board can anyone explain to me ??
Use "Virtual pins". This is a new option in PADS 9.5.
Thanks for your reply
if you know the answer for this post please reply in this post
i am using 2007.4 is it possible here ???
Since all T-junctions require a via, make a one pin part the size of the via you use, and use it instead of the via. On the schematic, add this part to each relevant net, one per net.
When are placing your parts, be sure all the pin pairs are correct, with all 3 pin pairs sharing the T point, then protect the topology. Now you can balance the branch lengths as well as the length to each load.
Retrieving data ...