3 Replies Latest reply on May 7, 2013 11:19 PM by kabaleeswaran.K.R

    fanout issue ??

    kabaleeswaran.K.R

      Hi everyone,

      In my design has 1762 components so i need to do fanout for all components (i have not pads Router) i need to clarify some details below.i am using PADS 2005.

      how to do the fanout with teardrop, which grid is best while fanout ??(because for tear drop the rats should be stright so it makes correct tear drop or else i could not get tear drop for fanout )

      is there any stript file is availalbe for Fanout ??

      shall i use reuse method for fanout because i need use same fanout for some IC (check image) or is it possible to copy the via with trace ???