4 Replies Latest reply on May 22, 2013 9:46 AM by cristian.filip

    Simulate stackup plane cut

    joao.1.monteiro.ext

      Hi,

       

      In Hyperlynx LineSim, is there a way to perform simulations taking into account cuts on a reference plane of the stackup in certain regions? Often they are used to change the characteristic impedance of lines (increase distance to reference plane underneath). However the stackup editor does not seem let me go into these kind of details.. It basically only allows me to define a complete generic stackup for the whole board.

       

       

      Thanks,

      JM