6 Replies Latest reply on Jul 23, 2013 8:09 AM by fmorgan

    Custom report question

    fmorgan

      So i have a rather large schematic with over 40 diagram pages.

       

      The default reports have a connector list i can generate but it comes up short because it does not tell me which Diagram that connector is on so my techs can find where its drawn quickly with paper copies.

       

      So a couple questions.

       

      Where is the Connector list report file hiding.

       

      And what code do I add to get the Design listed by each conector?

       

       

      And lastly why is there not just a nice pretty gui interface with check boxes of what I want in the order I wish to place it by collumn instead of doing this coding stuff.  MG pretty much has it for all the stuff i  can add to a custom wire name why not adapt that to an actual usable report generator?