0 Replies Latest reply on Aug 7, 2008 4:03 PM by Joel_Pointon

    Global Setting for Units (mm/inch)

    Joel_Pointon

       

      It is not currently possible to set default units for VeSys Components and so every time it is opened it reverts to metric units.

       

       

      In addition to this it would also be useful if there were one location where the default units of mm/inch/etc could be set for VeSys Design, Harness and Harness Reports, at the moment these ALL have to be set independantly.  Some of these are set in the drawing (which I do agree on the drawing does have to store the units just in case it is sent to someone else that has different default units) others the Configuration Editor, it would be useful to be able to set these in one location (likely in the Configuration Editor) so that any new drawings created all use the default units.