ogradyg

Troubleshooting program verify errors

Discussion created by ogradyg on Aug 23, 2013

I'm working with a new BSP for the Atmel SAM3U-EK and I'm getting an error when starting the debugger.

The project I'm trying to run is a stock Nucleus Serial Demo and my debug probe is a Segger J-Link.

 

In the Debug perspective, I have the following warnings in the Console tab:

 

warning: while parsing target description (at line 38): Register "CR" has unknown type "CR"

warning: Could not load XML target description; ignoring

warning: while parsing target description (at line 38): Register "CR" has unknown type "CR"

warning: Could not load XML target description; ignoring

Loading and verifying...

 

 

I get a pop-up window titled:

 

Error in debugger startup

 

 

With the pop-up contents as follows:

 

Failed to execute MI command:

-target-download C:/RSC/Products/Model400/fimware/test1/Debug/test1.out -verify

Error message from debugger back end:

Load verification failed at address 0x60000000

 

 

The debug session terminates when the pop-up is acknowleged.

 

Any suggestions on how to start troubleshooting this issue?

 

Regards,

Galen

Outcomes