1 Reply Latest reply on Oct 1, 2013 9:35 PM by Nuri

    Pin order

    fmorgan

      So when doing the cavity components Vesys Harness is not always putting the pins in alphebetical order.  See picture top half.

       

      Is there  a setting somewhere to force this?

       

      Also in Design is there a way to do the same thing with the connectors list?  Again see picture

        • 1. Re: Pin order
          Nuri

          Hi,

          I would have expected VeSys 2.0 Harness to show the cavities in the order defined under the "cavity names" tab in VeSys 2.0 Components, but that's not the case for me (even if I set the order to reverse).  Can I suggest that you raise an SR so that the appropriate action is taken.

          Thanks,

          Nuri