1 Reply Latest reply on Nov 4, 2013 5:46 AM by robert_davies

    Symbol Editor Replace Pin Properties question

    Thomas.DeSmit

      I have seen the "Replace Pin Properies" command in the DxDesigner Symbol Editor (NSE), but I haven't tried to use it until today. I was hoping to do a find/replace on the pin name, and the documentation seems to indicate that should be possible, but I ran into a snag. The drop-down list under "Find", is no list at all, the one and only property in the "list" is "Pin Number". Reading the Symbol Editor users guide, it says this:

       

      Find section — Defines property names and values to find and replace in a symbol design.

      Name

      Displays all pin properties in the symbol for you to select from the dropdown list.

      Value

      Defines the value of the pin property to find in the symbol.

       

      So, why isn't "Pin Name" in the drop-down?

       

      The symbol I'm editing has not be linked to a PDB yet, so this isn't a "freezeinterface" issue. Is there any way to get the drop-down list to actually be a list instead of one item?

       

      Thanks,

       

      Tom D.

      Aeroflex