1 Reply Latest reply on Nov 18, 2013 5:20 AM by Nuri

    Checking for correct wire gauge to ring terminal

    stefan1

      Hello,

       

      In my design I am using a ring terminal that accepts 16-22 AWG wires, so in the component library I filled out the “Single Terminations” attribute to include the appropriate wires. I later noticed that I had connected a 14 gauge wire to this ring terminal. I had synchronized the design, and ran all processes in the harness, but when I looked at the reports, this issue wasn’t flagged. I tried filling out the “Single Wire Fits Cavity” attribute, but this didn’t fix the issue either. Is there a way for me to check if the wire gauge is correct for single ring terminals? I am only able to check for the correct wire gauge when the terminals are in the housing for a connector.

       

      Thanks