2 Replies Latest reply on Dec 16, 2013 4:23 AM by erik.lundh

    Pads 9.5 Layout - change unroute behaviour.

    erik.lundh

      Hi again folks.

       

      I can't seem to find a setting for the unroutes (the small lines that symbolizes that an connection should be made).

      My actual problem is that they don't seem to behave like I'm used to (changed workplace and went from 9.3 to 9.5), which is that they always use the shortest path to the same net, at the moment they keep the path that were created when I ecoed to pcb the first time.

      I have a similiar problem when routing, I'm only allowed to draw a trace were the unroute are shown, i.e. if I have three pins (pin1, pin2 and pin3) and they have unroutes between pin1 and pin2, and between pin2 and pin3, then I'm not allowed to draw a trace directly between pin1 and pin3, even though they are the same net. I'm guessing that these problems are related.

       

      Regards,

      Erik