AnsweredAssumed Answered

Symbol Editor Error

Question asked by julio.liriano on Feb 10, 2014
Latest reply on Feb 10, 2014 by MENTOR_Shannonk

I am using Symbol Editor to create a new instance of a resistor. It has the same decal as another resistor so I've opened that resistor and "saved-as" a new resistor

and I went through and started changing the "PCB properties" to match the new part. The property "VALUE" was set to the old value, 1MEG. I attempt to change it

to "243K" and I get an error indicating it "expected a real value." I can write 2430000 into it but that is cumbersome. I want to be able to write 243K in there. Any clue

where I can change this setting?

Outcomes