1 of 1 people found this helpful
The Width and Thickness are taken from the "Base" tab in VeSys Components.
Tube's will have "Bore Size" and "Wall Thickness" attributes. The bore size is the Inside Diameter (ID) and will become the "Width" value in VeSys Harness for insulation runs.
I am not sure why there is a width attribute in the Extra tab.
Brian, I dont know if it matters but we are still on SP1310 so that might be part of it, but bore width is also set to 0.25 and it is not recognized. Do we need to update, we usually don't like to update till we get to a stopping point in design.
I doubt that the service pack has anything to do with it.
You will have to raise an SR with http://supportnet.mentor.com/
The insulation run's width should update as soon as you select the Tube part number from the Component Library.