7 Replies Latest reply on Jun 6, 2014 2:28 AM by g.giannopoulos

    Problem with the DxDesigner link from PADS layout

    g.giannopoulos

      Dear all,

       

      I am having a scary problem with the DxDesigner link.

      When I try to ECO a design into the PADS layout editor the DxDesigner starts and then I get the message that the project cannot be opened.

      If the project is already open in the DxDesigner I get no message but again the design is not transferred.

       

      In order to see if this is just my project I tried the same with the tutorial as described in the evaluation guide.

      I had the same symptoms, so I suspect a system error.

       

      Does anyone have any ideas?

      Perhaps something to check in the configuration or repair with the installation CD?

       

      Thank you

      George