6 Replies Latest reply on Jul 17, 2014 9:27 AM by c_afisch

    Diff Pair Routing

    c_afisch

      Hi all

       

      I have a question concerning routing of diff pairs.

      I’m using micro vias from layer 1 to 4, core via from 4 to 9 and micro from 9 to 12.

      BGA pins on layer 1 and caps on the bottom.

       

      When routing a single net I can easily drop down to the layer we need using the arrows to do so.

      When routing defined diff pairs, I cannot. I end up going to single net mode until both are on the layer I want then back to multi-plow.

      Is there an alternative to my time consuming method?

       

      Al