2 Replies Latest reply on Oct 22, 2014 2:04 AM by david-roseman

    Bottom layer of board flooded with hatch, others solid

    david-roseman

      Hello,

       

      I have a layout completed in PADS VX.0 where there are ground connected copper floods on each layer.  On layers 1-3 these are shown as solid fills, but on the bottom layer (4), an orthogonal hatch is displayed instead of solid copper.

       

      When I looked in the options, I could not see an options to change this setting on a per layer basis, how can I control this display, please?

       

      Regards

      Dave Roseman