0 Replies Latest reply on Apr 23, 2015 9:16 PM by agxinmj

    value of components are not properly getting exported

    agxinmj

      Hai

             I am having an orcad schematic the layout for the schematic is made with pads tool . In the schematic tool the vale of the resistor is 51 ohms

      Capture.JPG

      when i make the layout for the tool with pads i am unable to view the  value of the resistor when i export to hyperlynx the land pattern value is mapped to the value of the component

      i.eCapture2.JPG

      if you see 0402 is comming as 402 ohms how to solve this error