I just installed Pads Layout Viewer, it seems many functions at Layer Definition tab were disabled.
I have some asc board layout file shows following error. what can i do?
If you cannot change the layer definition to maximum layers in PADS Viewer, you can install the PADS Full version , open it in demonstration mode, change to maximum layer mode and import the ASCII file, but the only drawback is that the installation size is huge(>2GB).
or a simpler solution, ask the source of the ASCII file to send you the PADS PCB file.
thank you very much, it seems they disabled the maximum layers button, but this button can be used at version 9.5 so i go back to use the old version.
Retrieving data ...