2 of 2 people found this helpful
During the creation of the Part, all symbol pins must be mapped to a physical pin. The same is true from a cell stand point, they all must be mapped to a signal.
With that said, it appears as though that's a 22awg wire coming off pin 3. I would make a special plated hole where the "pad" is smaller than the hole and will be drilled out. That way the wire can be passed down through the board and ran to the front panel along the back side. This way you have 4 electrical connections but one will disappear.
Hi Jeremy Thank you that works.
Thanks Jeremy, this is the same approach that we have used, so it is nice to know that other people used this technique.