I need to write rule file to find the length of the net connected to the port. I've been looking around the manuals but can't find an example. Would you please help?
Binh - thanks for your question. I am going to move it to the Calibre community for better visibility and quicker response.
I'm not aware of an easy technique for finding the length of a net connected to a port but there is a TechNote that describes a way to check for "long" nets in Calibre DRC. Here's a link to that TechNote in case it helps:
The link https://supportnet.mentor.com/portal?do=reference.technote&id=MG15133 does not exist anymore. Could you please kindly point to me where this technote is now?
That link redirected for me to https://support.mentor.com/en/knowledge-base/MG15133 ; does that link work for you?
Yes, this link works for me.
Thank you for digging it out.
Retrieving data ...