1 Reply Latest reply on Sep 28, 2015 1:20 PM by James.Wilkinson

    Replace symbol for a harness connector

    cqersyh

      Hello,

       

      I am trying to create harness connector myself. Firstly the new symbol I drew was OK to be attached to the connector in Vesys component maintenance. However, when I was synchronizing from wiring to harness (this connector was used in the project), it seems like the Vesys harness is using the default unknown symbol. I tried a few times by replacing other connector with different symbols, everything works fine. The thing I found is that when I attached the comment symbol I drew to any connector, it would not recognized. Does any of you are aware of how to draw a comment symbol so that it can be attached to connector and synchronize correctly?

       

      For the comment symbol I drew, I put several rectangular and circular lines there and saved to draft library. In the vesys component tool, I could create a connector with comment symbol attached.

       

       

      Many Thanks

       

      Andrew