1 Reply Latest reply on May 11, 2016 4:35 AM by .-.--.--

    Xpedition VX - Backdrill analysis

    Arunraj

      Hello All,

       

      I stopped with a problem in back-drill analysis, I need to do back drill for a through hole component pin (Its like a press fit, so no issues in back-drilling this particular through hole comp) so I ran it through back-drill analysis but it shows the back drill side from both side of the board.

       

      This led to confusions on side of back drill. Any help on fixing side of back drill for through-hole components.

       

      Here is an example for you, a signal routed on layer 3 and its a through hole pin but after the back drill analysis it shows both side of the board.

       

       

      Thanks!

      Arunraj