0 Replies Latest reply on Apr 26, 2016 4:12 PM by coupland350

    Area Cut Trace Command

    coupland350

      Hello,

      When trying to use the "Area Cut Trace" command the job locks up. In the lower tab it states that the command is processing but it just sits there @ 0%. I eventually have to just manually crash the job. Is anyone else having this issue? I'm using  X-ENTP VX.1.1. I'm not sure if it matters, but I do have the older versions of software installed on the same computer. (Ex:7.9.1, 7.9.2, 7.9.4 and 7.9.5).  Any feedback would be greatly appreciated.

       

      Randall Bennett

      Sr. PCB Designer

      Palpilot International(512) 731-3759