AnsweredAssumed Answered

DX Designer discreet comp. value

Question asked by addispcb on May 5, 2016
Latest reply on May 5, 2016 by addispcb

The discreet components symbol that I downloaded from PartQuest is showing the value in farads instead of uf eg. 0.0000047 farad instead of 4.7uf. The same thing with the resistor value 5600 Ohm instead of 5.6K. Is there anyway to change this globally in DataBook or is there any setting I should use when importing from PartQuest?

Thank you in advance for your support.

 

Outcomes