I have a design which will use different trace widths depending on the layer it is routed on.
There are impedance requirements which dictate the trace width depending on the layer.
Is there a way to setup rules or constraints that change to the appropriate trace width depending on the layer the trace is being routed on.
I have numerous nets that have this requirement and would like to know if I can group select and setup the rules or constraints.
That ability is part of Conditional Rules, but only if you have the High speed option.
An alternative method is to route all traces at the widest width, then change them after the routing is finished layer by layer. Not ideal, but it gets the job done.