0 Replies Latest reply on Feb 2, 2017 5:29 PM by malgumhasan@gmail.com

    Designing 1-825433-4 header in pads logic.

    malgumhasan@gmail.com

      Hello,

      Similar to xdxdesign, I wanna make a header as follows, take a look .

       

      header_1.PNG

       

      In Pads logic, I have go through, Tools>Part Editor then File>New,

      It shows,

      eaditing iteam.PNG

       

      I have selected "connector" and clicked OK.

      After this what should I do in "Edit Electrical" as follows ? Connector section is here.

       

      new_connctor.PNG

       

      How to enable drawing tools then?

      Do you think this one? all pin editing tools are inactivate!

      drawing_tools.PNG