Hello All ,
Please provide guidance for the timestamp message generated while updating part type in PADS LOGIC .
Find the attached picture for the same .
Best Regards ,
Parth Sutariya
Hardware CAD Engineer
MATRIX COMSEC PVT. LTD.
R&D Center
190, G.I.D.C Makarpura
Vadodara-390010, Gujarat-INDIA
Hi Parth. I've moved your question to the PADS Logic sub-community where it should receive a quicker answer.
It tells you that the part type in the library has an (auto generated) timestamp that is older than the one used in your schematic.
This means that you may have modified the parttype in the schematic so it is now newer than the one in the library.
I will suggest to check the actual differences and then decide whether to update from the library or not.
Regards Klaus
Hello Klaus ,
You mean to say that this message appears when part is modified at design level in schematic and not in actual CAD library .
Is it so ?
Best Regards ,
Parth Sutariya
Hardware CAD Engineer
MATRIX COMSEC PVT. LTD.
R&D Center
190, G.I.D.C Makarpura
Vadodara-390010, Gujarat-INDIA
Yes - it could be.
E.g. if an attribute is modified/added or similar.
However it does not say aything regarding what the changes are.
You can see the changes by running a 'Compare' instead of an 'Update'.
Like in the example below where the 'Value' attribute is updated directly in the design.
regards
Klaus