3 Replies Latest reply on Nov 7, 2017 1:12 AM by dbertocchi

    Unable to place a through-hole test point

    vtolenti

      Hello,

       

      For some reason I am not able to place a test point in a specific region of my layout. Even though there is apparently no conflict, Mentor displays the following message "Cannot resolve immovable metal conflicts".

      I am trying to place the test point TP3 between the resistors R24 and R23 but mentor does not let me to. There is another copy of this configuration (connector + resistor + test point ) located in the lower side of the board and it works fine and I do not experience any clearance violations.

      Do you have any idea why this warning message is popping up?

       

       

      Best Regards,

      Victor Tolentino