6 Replies Latest reply on Dec 19, 2017 1:59 AM by robert_davies

    How to draw a power track line and signal track line in schematic?

    aizathashimste

      Hi,

       

      Currently I'm working on a charger board so there's a power line track and a signal (low power) line track.

       

      How can we separate the Line Width on the same net in a schematic?

      Refer below for an example:

       

      If I change the track width to thick track between LC1 and SRC1 net, the whole net (pin 15 and pin 14 of U1) will be followed but I'm intended to change at the selected net only.

      The net between pin 15 of U1 and SRC1 and pin 14 of U1 and SRC1 should be in thin line due to small signal line.

       

      What is the method to fulfill my intention above?

       

      Appreciate your support.

       

      Aizat.