This content has been marked as final.
Show 5 replies
-
1. Re: How to make "Jumper" holes plated
vinayarora May 10, 2018 10:25 AM (in response to charl.peters)They are plated by default.
Just specify the pad and drill size.
-
2. Re: How to make "Jumper" holes plated
charl.peters May 10, 2018 8:11 PM (in response to vinayarora)According to the Drill table they are not plated.
-
3. Re: How to make "Jumper" holes plated
vinayarora May 11, 2018 7:36 AM (in response to charl.peters)You are right, seems like there is no option to make them plated.
I remember seeing a single sided board with lots of bus wire jumpers, which were inserted in the hole and soldered on the surface.
-
4. Re: How to make "Jumper" holes plated
vinayarora May 11, 2018 7:50 AM (in response to vinayarora)What's layer structure?
I created a four layer board and add jumpers and drill shows as plated.
There are no thru hole parts.
M48
;FILE_FORMAT=3:5
INCH,LZ
FMAT,2
ICI,OFF
;TYPE=PLATED
T1C.037
%
M72
G90
G93X0Y0
T1C.037F197S55
X0034Y0017
X0034Y001925
X003625Y001925
X00385Y001925
M30
-
1.gif 7.1 KB
-
-
5. Re: How to make "Jumper" holes plated
vinayarora May 11, 2018 8:00 AM (in response to vinayarora)Two layer board also shows jumper hole are plated.
M48
;FILE_FORMAT=3:5
INCH,LZ
FMAT,2
ICI,OFF
;TYPE=PLATED
T1C.037
%
M72
G90
G93X0Y0
T1C.037F197S55
X00152Y00124
X00152Y001415
M30