I face issue in exporting ODB++ in Version VX2.2, When the layer count is more than 40 , When the boards are with dense components and When the boards has minimum copper width (2mils-- for fine pitch BGA).
Do you guys has any idea to over come!!
It will help if you tell us about the issue you face.
Here the details,
Once the CAM setting are done, I ran Pour Manager to fill all planes shapes with copper. Once it done, I did below ODB setting and click OK.
Its Run for more than 30 mins(Shows status in bottom left as saving database, Exporting aic, etc).. then after few mins its end up with fatal error.
I dint see any error details in report file, only warning details..
Please let me know your comments and suggestion to overcome.
I would uncheck the first two options and chose "Prefer Drill" for Non shape Drill.
I suspect IPC-2581 is having an issue to generate properly.
Did you try exporting the Layout to ASCII and re-import it ?
If it fails, you have the answer.
Will check on the above and get back ..
Again its end with Error(Operation aborted). Will try to Export and Import Ascii
What is the error reported ? Your picture shows only warnings.
Just noticed you used ODB++ V8 ... don't ... use V7
Report file contain only Warning , No Error massage.... I will try using ODB++ V7
Have you defined some Assembly Options in the design? If yes - try to delete them before creating the ODB++ file.
I have seen errors when assembly options are defined.
I think it is supposed to be fixed in VX.2.2 - but you'll never know?
I have also seen issues if using certain local language characters in filenames and folders.
Retrieving data ...