AnsweredAssumed Answered

how could I change the sequence of the placed boards (Fablink)

Question asked by markus.fischer on Feb 3, 2019

Hi Folks,

is it possible to change the sequence of placed boards in fablink?

 

If you use the GenCAD of fablink for manufactoring, the position and numbering of the boards are defined by the order of placeing the boards. And this order must not be the prefered order of the Manufacturer. So, in the GenCAD file is an other board no. naming, than in the Panel drawing

Yes, it is profitable and desirable to place the boards directly on the right Position in the right sequence. But sometimes it is not possible.

 

So, did anyone know a possible way tho renumber the placed boards without "cut and paste"?

Thanks a lot in advance!

 

Kind regards

Markus

Outcomes