In my current pdk, I do not have a CAPACITANCE ORDER statement in my rules file for CalibrexRC.
Is there an example of this statement I can add to my rules file to enable a PEX verification run?
Currently using Calibre DESIGNrev v2016.1_14.11
aguzman - thanks for your question. I am going to move this to our Calibre-specific IC Design community where it will receive greater exposure. The Members Resources area is for general community questions and suggestions.
Here is a KB article that describes this issue:
Start by checking to make sure the paths in the rule file and Calibre Interactive are full paths and that all environment variables specified in the rules are set appropriately.
Retrieving data ...