AnsweredAssumed Answered

PADS Layout 9.5 Gerber data is inconsistent with PCB design data

Question asked by zero on Apr 17, 2019
Latest reply on Apr 22, 2019 by kbak

PADS Layout 9.5

Gerber data is inconsistent with PCB design data

 

The signal hole in the PCB drawing is the L1-L3 laser hole. When the gerber is output, the L2 layer is completely covered by the ground copper, causing a short circuit; it is normal to return to the PCB drawing.

There are thousands of holes of the same type, only one is currently found, but it has caused significant losses.

 

As shown in the figure is PADS Layout display, the bottom is gerber tool display.

PADS Layout

Capture_PCB.PNG

 

gerber tool

Capture_gerber.PNG

Does anyone know why and how to avoid it?

Outcomes