AnsweredAssumed Answered

signal routed through conductive shape

Question asked by stempialdo on May 9, 2019
Latest reply on May 10, 2019 by stempialdo

Hi there,

 

I am using a conductive shape on top of 2 pads to connect them, this because it's part of a specific copper shape. The two pads are to be connected together in the netlist too.

Electrically will be fine, but I am still getting a batch DRC error because Layout thinks the two pads are not being shorted (I can't run a proper track on top of the shape in this instance).

 

Is there a way to let the system know that the conductive shape is doing the job?

 

 

Cheers

Flavio 

Outcomes