Hi I'm trying to link my design in pads logic to my design in pads layout and am having some trouble. So far in pads logic I have clicked on tools, then pads layout and then went to the document tab in the pop up box and selected the layout file that I have pulled up side by side my logic window. In output window in logic, I can see that I have successfully connected to layout. I then clicked send netlist in the design folder, also successful according to the output window. However at this point all the tutorials I have been following state that the components from logic should appear in the layout and can be easily seen with the disperse components tool. However, I am not seeing any of the components that I currently have in logic in my layout even though they are linked. Any suggestions? Thanks!