Is it possible to put nets like make it GND or VCC of NC (or no nets) pins on components in PCB layout?
long: No, because its a schematic driven layouttool with no possibilities to edit the PCB Netlist in the layouttool without sync to schematic (instead of eg PADS ). And this is very good!
Workaround: In our lib is every physical pin in symbol, also all NC Pins, so it would be theoretical possible to connect NC to any net. This also helps for class2class rules to include all NC Pins. I totally recommend to build a lib with all NC Pins included in Symbols!
Thank you for the answer, Daniel.
Turn on this option in Project integration window
Thank you, pbo!
Assign single pin nets to unused pins, enabling fanout was checked already but but cannot still add net to the NC pins.
I tried using NETLINE MANIPULATION, ASSIGN NET, and ARRANGE NET but it doesnt allow to add a NET (example GND net) to the unused pins.
You need to run forward annotation after enabling this option
Sorry i'm forget that you need also turn on "enable fanout of single pin nets" in Route tab of Editor Control
And after that run FA
you can only fanout nonconnected Pins with a net called Net-0(xxx) not assigning a net of the Netlist to it. There is no such a thing like PADS ECO Mode in Xpedition.
Only for Mounting Holes its Possible to assign GND or any other Net
Retrieving data ...