Is there a way to mirror everything including board, components, mounting holes, traces at the same time.Basically, I need to flip the board over to the other side with all components and traces on it.
Display Control - Mirror View
Display Control - Mirror View will only flip the view, it is not flipping the actual data. If you want to flip the actual data the following procedure can do that for you.
Note that i am using VX2.6. I am not sure if this can be done in earlier releases. It might happen that you also want an other rotation after the flip. You can do this by typing the keyin command 'ra <angle>'. This will rotate everything with the specified angle.
charles.ietswaard That was helpful. I got that work with my test board. However, when I try to mirror flip my real board it does not allow me to mirror everything at the same time.
Separately it allows, but it is huge manual work.
DRC is off, everything is unlocked.
I noticed that in some selection it allows to mirror and in some it does not. Haven't yet figured out what is causing that.
There should be option where you can flip board around X or Y axis of origo in Layout.
Here it does not allow.
Here it allows when less components are selected. However the quantity of components has no effect.
If you have items (e.g. an placement obstruct) of a cell selected but the cell itself is not selected it will disable the push command.
Try selecting with the cell origin for top and bottom enabled (make sure the origin of both sides are visible).Drawing cells with copper texts can also give issue so best to move them away
Retrieving data ...