AnsweredAssumed Answered

Decoupling Wizard: not finding power net

Question asked by xenxo on Aug 20, 2020

Hello,

 

I have defined the power nets (GND & VBAT):

 

 

However the decoupling wizard is not finding the VBAT:

 

Is there anything (I guess basic) that I am forgetting?

Furthermore, the VBAT comes externally through a pad (which is soldered to a battery), is there functionality in Hyperlynx to specify this? It would let you do if it comes from a IC pin, resistor, inductor, etc. but not from a pad.

 

I would really appreciate any feedback.

Xenxo

Outcomes