1 Reply Latest reply on Oct 9, 2009 4:05 PM by yu.yanfeng

    Defining layer set for autorouter

    rasit.gumus

      Hello to all

       

      I want to define routing layer sets on the expedition pcb and keep routing within the layer set. For example define layer set 1 (LS1) as signal layer 1,2 and 3 and LS2 as signal layer 4, 5 and 6. If the router starts to route a signal on layer1 , i want it to be routed only using layer 1,2 and 3. And if the router starts to route a signal on layer 5  i want it to be routed only using layer 4,5, and 6.

       

      Is it possible?

       

      best regards

       

      Rasit GUMUS