1 Reply Latest reply on Feb 5, 2010 1:34 PM by karen_chow

    warnings messages during calibreview generation

    daniel_ong

      Generating the calibreview is taking a long time for a small block. GDS file size is just over 100MB but this step is taking over 10 minutes.

      There are lots of similar warnings in the output log (see below). I was wondering if suppressing these warnings will enable the step to complete faster?

      Any suggestions? Thanks.

      -Daniel.


      WARNING: Schematic instance 77/0/0 not found.
      WARNING: Schematic instance 77/1/0 not found.
      WARNING: Schematic instance 78/0/0 not found.
      WARNING: Schematic instance 78/1/0 not found.
      WARNING: Schematic instance 79/0/0 not found.
      WARNING: Schematic instance 79/1/0 not found.
      WARNING: Schematic instance 80/0/0 not found.
      WARNING: Schematic instance 80/1/0 not found.
      WARNING: Schematic instance 110/R0 not found.
      WARNING: Schematic instance 110/R1 not found.
      WARNING: Schematic instance 110/R2 not found.
      WARNING: Schematic instance 110/R3 not found.
      WARNING: Schematic instance 110/R4 not found.
      WARNING: Schematic instance 111/R0 not found.
      WARNING: Schematic instance 111/R1 not found.
      WARNING: Schematic instance 111/R2 not found.
      WARNING: Schematic instance 111/R3 not found.
      WARNING: Schematic instance 111/R4 not found.
      WARNING: Schematic instance 112/R0 not found.
      WARNING: Schematic instance 112/R1 not found.