How does it work when using Auto-Route to perfom rounting of T-Topology and length matching of signals?

Discussion created by bongani on May 26, 2010
Latest reply on May 26, 2010 by yu.yanfeng

I have PCB design that requires the use T-Topology and length matching, so I did T-Topology rules setup using CES.

for example the T-shape net or signal consist of Source to Virtual Pin, Virtual Pin to Load (in this case there are two loads, L1=L2 in length matching), I have tried to use Auto-route, but it perform the undesired results by routing the whole net, how can I make the Auto-route to route only the portion of net from virtual pin to the two loads without routing the other net portion from source to virtual pin?