AnsweredAssumed Answered

Design Verification - Fabrication

Question asked by m0khz on Jun 28, 2010
Latest reply on Jun 30, 2010 by kbak

Second query using PADS 9.1 Tools>Verify Design


My layout has been done primarily within Layout with the Design Rules Prevent (DRP) enabled. When I perform Design Verification with the Fabrication check box ticked, I see reported a large number of DFF Errors, i.e Silver on Top Components.


On closer inspection it seems that the Facrication verification doesn't like the tight angles of some of my tracking, but these have been laid down with DRP enabled?


Once again am I missing something here?