2 Replies Latest reply on Jun 28, 2012 3:53 AM by robert_davies

    Constraints are grayed out in underlying schematic of Hierarchical block

      Flow: DX/PADS

      Version: 9.2

       

      I have a Hierarchical Schematic, at the top level when I push into the underlying schematic the constraints on some nets are not available for editing.

       

      If I choose the Block (that is being referenced) from the project navigator I am able to edit the constraints for these same nets, is this a restriction on editing constraints in underlying schematic pages?

       

      I would then expect that if I edited a value (ie: track width) on the Block level that this change would show up on the net when I push in through the Hierarchical block, but it does not.  Am I missing a step somewhere?

       

      Regards:

      Brian.